KISS FCFC‑Ultra V2 Flight Controller

Features

• Iconic KISS “H” form factor 30.5x30.5mm mounting (With permission of Flyduino)
• STM32H743 processor 480 MHz, 2MB FLASH, 1.28MB RAM
• IIM-42652 gyro, SPI
• BMP388 barometer
• 8 pin ESC connector, backward compatible with KISS (!!!not with FETTEC!!!).
• Includes current sensor pin.
• Extra solder pads for motors 5-8
• 2 serial ports on 6 pin connectors (SER1 / SER3), KISS compatible
• Overcurrent protection on all data lines
• ESD protection on USB
• 5v bec (2A) with separate power on lipo and on usb. 8s capable.
• Integrated spike absorber
• Dedicated current sensor pad

Software Improvements

• Firmware is based on LATEST version from PATREON
• New STM32 H7 bootloader, VCP driver
• One HEX to rule them all… ??
• Smart config storage… NEVER loose your configuration…
• Optimized hardware interface layer code
• Optimized adaptive filter code (CPU load is about 8% fully loaded!!!)
• Added BLHELI Passthrough
• IRC Ghost support
• TBS CSRFv3 support (ultra code)
• Improved RTH with BARO support
• KISS Weather Station (its fun)
• NO soft serial ports anymore!
• 7 serial ports exposed (dedicated serials for SA and RC telemetry)
• Camera control (analogue, real DAC)
• UBX protocol GPS support
• Battery capacity/alerts
• DSHOT router (free routing between software and hardware channels)
• Up to 8 motors support with DSHOT2400/1wire
• Full support of all HD systems (DJI MSP, DJI WTF, DJI O3, Walksnail, HD0)

Includes

• 1x KISS ULTRA V2 30x30 Flight Controller
• 1x 8-8 Cable
• 1x 8-6 Cable (legacy)