5.8GHz 48CH 25mW/3000mW Transmitter VTX

1. 5.8G 48 frequency points: (A.B.E.F.R.L; 5362MHz-5945MHz);
2. Maximum power: 3W (25mW/1000mW/2000mW/3000mW,adjustable);
3. Input voltage: DC 7V-36V, support 2-8S battery input.
4. Antenna interface: MMCX
5. Communication protocol: IRC
6. Fan heat method: aluminium alloy heat sink + fan
7. Mounting hole: 30.5mm*30.5mm / ø3.15mm
8.Product size: 37.7mm*36.1mm*11mm
9.Product weight: 16g

1. Frequency point indicator: red LED
2. Frequency group indicator: blue LED
3. Power indicator: green LED
4. Frequency band and frequency point adjustment button
5. Power Adjustment Button
6. 1.0 6P cable holder
7. MMCX antenna holder

1. Button ④ is used to switch band and channel; every time when button ④ is pressed for a short time to switch to the next channel, the red LED ①will flash, 1.2.3.4.5.6.7.8 in turn. The operation can be cyclic; see the following diagram for details!

2. Band will be switched if button④is pressed for a long time and the blue LED will flash if the key is pressed for 5s, A.B.E.F.R.L in turn. The operation can be cyclic; see the following diagram for details!

3. Button⑤is used to switch RF power, every time when button⑤is pressed for a short time to switch to the next RF power level, RF power cycling between 25mW, 1000mW, 2000mW and 3000mW. Green LED is the RF power level indicator and its status is shown in the following diagram. 25mW LED will flash once, 1000mW twice, 2000mW for 3 times and 3000mW for 4 times. When the button is pressed and held for morethan 3 seconds, the Transmitter will enter pit mode,the green LED will remain permanently on. See the following diagram for details!

Notice: The transmitter is equipped with temperature protection function. When the temperature of transmitter is higher than 100C,the RF power of the Transmitter will be lowered for one level. If the temperature is still greater than 100C, the power can be lowered for another level until the lowest power (25mW) is reached; at this time, the temperature of the Transmitter module will drop. When the temperature is lower than 95C, the Transmitter power will return to the originally power level.

Frequency Table:

6P 1.0 cable interface definition:

Precautions for use:
1. the map transmission installation must leave space to ensure that the module around the air convection, to ensure that the module heat; otherwise the module overheating protection start, reduce the power to launch, or even shut down the power to launch.
2. it is recommended that before turning on the power, to ensure the correct voltage range, positive and negative poles correct, so as not to burn components.
3.it is recommended that before turning on the power, make sure that the RF RF output has been installed antenna, which can prolong the life of the module.
4.Please read the manual before use, so that you can correctly wired to extend the life of the module.

Package Included:

1 x 5.8G 25mW/1000mW/2000mW/ 3000mW VTX
1 x MMCX interface antenna connection cable
1 x 6P 1.0 connecting wiring